canon pixma mp990 printer error has occurred

#CANON PIXMA MP990 PRINTER ERROR HAS OCCURRED HOW TO#
#CANON PIXMA MP990 PRINTER ERROR HAS OCCURRED SERIES#

I cannot clear the 5B00 error message (for example by depressing OK when the message just used to say the ink pad was getting full). There is a flashing Blue and flashing Orange light alternating off and on.

Realize that when the 5B00 error display is present that none of the electronic lights are lit. Thus the Easy Way to Reset a Canon Printer to overcome the 5b00 error, hopefully, your printer works and works without any obstacles. Advice admin takes the printer to the nearest service centre to reduce the risk of other damage. but if the two steps above have been tried and the results have not been able to repair your printer. The author’s experience in this way is effective. Press and hold the Stop/Reset button, then release the Power/On and Stop/Reset buttons together.Press and release the Stop/Reset button 5 times.Release the Stop/Reset button (the Power/On button is still pressed).Press then hold the Stop/Reset button and the Power/On button.

#CANON PIXMA MP990 PRINTER ERROR HAS OCCURRED SERIES#

There are different ways according to the Canon printer series, you can also try the following methods for the PIXMA MG series and also on other common series. If you have released all the power and resume buttons simultaneously.

After that, press the resume button which is orange six times and the last one is held.Then release the resume button which is orange.Then press the Power button that is green and hold it too, so the power and resume buttons are both held.Then press the button under power, the resume button and hold it.In resetting the printer without software, your printer must be in a state of inactivity.

#CANON PIXMA MP990 PRINTER ERROR HAS OCCURRED HOW TO#

Then turn off the printer and turn it on again.Īfter the printer reboot, the Error 5b00 does not appear again, if the error message shows up again, you can try to fix the 5b00 error by resetting the printer without software, you can follow the step below: How to Reset a Canon Printer Without Software.

Then click the “EEPROM” button, in this process, the printer will output the Resetter, check the line generated from the print process whether there is a word “TPAGE (TTL=00000)”.

Then you click the “EEPROM Clear” button.

Double-click the Resetter software, then click the “MAIN” button, usually, after clicking the “MAIN” button the printer will print one page with the words “D=000.0”.

Prepare 2 sheets of paper in the printer’s paper feed.

Canon pixma mp990 printer error has occurred